Riello-ups PowerShield³ Bedienungsanleitung PDF herunterladen (Seite 35)

UPSMON User Manual Advanced UPSMON Configuration • 35

Parameter name Parameter description

Save files before shutdown

When selected, the Upsagent will try to save any open files before the system shutdown is

started. This function is not be supported by all programs or some international variant of

standard programs. Only standard Windows applications are supported (e.g MS Write, MS

Office and more…).

ATTENTION: If the Upsagent system shutdown does not work correctly, it may be

due to an incompatibility application or conflict with possibly the “Save files

before shutdown”. To ensure correct shutdown this may have to be disabled if

problems persist.

Hibernate support

When selected it enables the possibility to suspend the system instead of a normal shutdown.

This function is supported by Windows 2000 and higher on supported hardware.

In the “List of events” section, the user may define the actions to be taken when a given event is detected on the UPS or on the sensors

connected. A number of actions can be associated with a particular event on the UPS or on the sensors connected, such as for example

the possibility of executing a series of external commands defined by the user. A runtime delay can be programmed for the actions

associated with a particular event (so as to filter events that only last for a short time). Similarly, an interval can be programmed for the

repetition of the action, should the associated event still be active. Both values are expressed in seconds.

Action name Action description

Disable all jobs

Enables or disable all of the jobs, if selected no jobs can be executed.

Generation event delay

The event that occurs is recognized by Upsmon only after the specified delay.

Message

It is possible to alter the default message for a particular event. It is not recommended to change

the basic message text, as this may cause an incorrect message to be sent, which does not

correspond to the actual event.

Note: in the message text it is possible to add actual values or information which will be

displayed along with the original information, these are as follows:

$NAME The UPS or Group name will be added to the message (See main

parameters dialog box).

$SYSNAME The System name will be added to the message (See main parameters

dialog box).

$SYSLOC The System location will be added to the message (See main parameters

dialog box).

$SHUTTIME The time before shutdown of the local system in seconds.

$SHUTTIME1 The time before shutdown of the local system in the format: hh:mm:ss

$STH, $STM e $STS The three values: the time before the shutdown of the local system in

hours, minutes and seconds.

$REMTIME The remaining UPS battery autonomy.

$REMCAP The remaining UPS battery capacity.

$SENSORNAME Name of the sensor on which the event occurred. Valid only if events

have been associated with the sensors.

Log event

If selected the event will to be logged into event log file.

ATTENTION: On Windows NT,2000 or XP platforms the events are also logged in the

system Application event log. On UNIX platforms the events are also logged into the

system log (this depends on system configuration: see syslog manual).

Execute file

If selected the Upsagent will execute a specified command file when a selected condition occurs.

Recommendation: Always use the full path name for the file.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 82 83

Kommentare zu diesen Handbüchern

Keine Kommentare

Riello-ups PowerShield³ Bedienungsanleitung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Riello-ups PowerShield³